Industrial Desiccant Dehumidifier Equipment For Pharmaceutical Production

Dehumidification principle
The adsorption rotor worked as core parts of dehumidifier adopts high strength adiabatic material as base material and has honeycomb shape pipeline structure. Complex adsorbent form a huge adsorption surface in the substrate equably, in order to guarantee the maximum contact then achieve dehumidification purpose effectively. Dehumidifier sealing devices are divided into 270o sector, and the regeneration of the area is 90o. It adopts positive pressure air flow and silicon-fluorine elastic sealing material in the runner around closely, and the area between desiccant area and regeneration area are also designed elastic closed. The raw damp air which need to be handled(process air) is delivered into rotor dehumidifier area by process fan, then the relative low humidity can be get after the moisture in the air absorbed by adsorption. In the meantime, the regeneration air will into rotor process area reversely after heating(110~140). At there the the water which is absorbed by absorbent will be take out and away. This step can recover the moisture absorption ability of absorbent. The runner has a slow speed as 18 rotate per hour. The whole process is a recycle system between dehumidification and regeneration to ensure continuous dehumidification effect and get dry air stably.

Technical parameters
The rotor dehumidifier controller use high-performance SCM with the function of self-check, power off memory, LCD Backbit display, regular operation, Temperature and humidity conditioning, accumulated running time, error tip etc. The system can be operate flexible and safety. It's very suitable for humidity controlled places.

1.The Main Parameters:
Working voltage: 220V/50HZ
Applicable environment temperature:-10~+55
Applicable environment humidity: less than 95%
Applicable environment gas: no corrosive gas
Humidity sensor precision:±3% RH
The temperature sensor precision: 1

2.Basic Function
Environment humidity display
Environment temperature display
The outlet temperature display
The whole machine working current display
Fan operation symbols
Electric heating operation symbols
Rotor motor running symbols

The operating instruction
There are 4 buttons in the machine panel:ON/OFF,SET, +,-

1.ON/OFFfunction
In powder off, click this button once, enter the boot state.
In powder on, click this button once, enter the shutdown state.
Press this button continued is invalid.

2.Basic setting

1). Clocking setting
After power on, the buzzer rang sound twice, it's available for us to set current time after LCD display clock flashing. The steps are showed as below:
Mode 1: Click once the plus or minus button, the minutes plus or minus 1 minute.
Mode 2: If you hold the two buttons 3 seconds, the mode changes to even plus or minus mode, the minutes plus or minus 10 minute after Clicking once the plus or minus button.
Mode 3: If the minutes reach to 60, the mode changes to hour model, plus or minus 1 hour once you click om the button.
After finishing the setting, the flashing clock will flash fifth as mark.
Ps: Setting is not allowed when the flashing clock is flashing.

2). Heater temperature Settings:
The setting can be done when the Press the LCD display electric operator and the temperature flashing after click theSET button 1 time. Click once the plus or minus button, the minutes plus or minus 1 degree. If you hold the two buttons 3 seconds, the mode changes to even plus or minus mode. After finishing the setting, the flashing clock will flash fifth as mark.

3)The wind humidity Settings:
The wind humidity can be setting when the LCD display humidity flashing after click the setting button twice. Click once the plus or minus button, the minutes plus or minus 1%RH. If you hold the two buttons 3 seconds, the mode changes to even plus or minus mode. After finishing the setting, the flashing clock will flash fifth as mark.